Brake Pads - Vehicles With: 324 Mm Brake Disc (G2782929): Removal

CAUTION:

Brake pads must be renewed in axle sets.
If the brake pad wear warning light has been activated, a new brake pad wear sensor must be installed.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.
This procedure contains illustrations for right side components, left side components are similar.

- Use the Jaguar Land Rover (JLR) approved diagnostic equipment to set the Integrated Power Brake to the assembly mode.
  Refer to: INTEGRATED POWER BRAKE ASSEMBLY MODE
- Use the JLR approved diagnostic equipment to set the Electric Park Brake (EPB) to the maintenance position.
  General Equipment: Jaguar Land Rover approved diagnostic equipment
WARNING: Take extra care that the brake pedal is not pressed during the replacement procedure. Failure to follow this instruction might result in personal injury.

NOTE: This step is only required if the JLR approved diagnostic equipment is not available.

Set the EPB to the maintenance position.

Refer to: ELECTRIC PARK BRAKE SERVICE MODE ACTIVATION AND DEACTIVATION
Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING
Remove the rear wheel and tire.
Refer to: WHEEL AND TIRE
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the brake caliper anti-rattle spring.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the electrical connector.
CAUTION: Care must be taken for the brake pad wear sensor is easily damaged.

NOTE: The brake pad wear sensor is only installed on the right side brake caliper.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the brake pad wear sensor from the brake pad.
- Release the grommet from the bracket.
- Reposition the wiring harness away from the brake caliper.
CAUTION: Make sure that the brake hose does not support the full weight of the brake caliper assembly.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 2 brake caliper dust covers.
- Remove the 2 brake caliper slide pins.
- Reposition the brake caliper to get access to the brake pads.
- Use a suitable cable tie to support the brake caliper.
  General Equipment: Cable ties
NOTE: Note the orientation of the brake pads prior to removal.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the brake pads.
Repeat the steps 4 - 9 for the other side components.