Head Up Display - If Equipped
The Head Up Display (HUD) control module receives a permanent battery voltage supply via the Rear Junction Box (RJB). A High Speed (HS) CAN comfort systems bus connection allows the HUD to communicate with other modules such as the Instrument Cluster (IC). The IC - virtual display is also connected to the HUD via Automotive Pixel Link 2 (APIX2).
The HUD is controlled from the message center.
When selected, the menu offers the following options:
- Selecting the vertical position of the display on the windshield (a temporary border will be shown in the Head Up Display (HUD) image when adjusting the position).
- HUD brightness setting, with rain/light sensor input. The rain/light sensor is not linked to the vehicle dimmer switch.
- Selecting which information is displayed on the HUD.
For additional information, Refer to: EXTERIOR LIGHTING
For additional information, Refer to: INFORMATION AND MESSAGE CENTER
The Head Up Display (HUD) showroom mode is controlled from the Instrument Cluster (IC) service menu and displays example images on the windshield when the vehicle is stationary.
Prior to selecting the HUD windshield position the user should select their desired seating position. The steering wheel controls are used to set the horizontal position of the windshield display. Once set, the information can be saved in the seat memory control system, storing the selected preferences.
For additional information, Refer to: SEATS