LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2021 >> Range Rover Evoque R-Dynamic S >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Vehicle Dynamic Suspension -- Range Rover EVOQUE/L551 >> Vehicle Dynamic Suspension >> Removal And Installation >> Rear Suspension Height Sensor (G2297998) >> Installation

Rear Suspension Height Sensor (G2297998): Installation

    • Install the suspension height sensor to the vehicle.
    • Install and tighten the 2 bolts.

      Torque  : 9 Nm 

  2. Connect the suspension height sensor link.
  3. Connect and secure the wiring harness.
  4. Install the wheel and tire.

    Refer to: WHEEL AND TIRE .

  5. Using the Jaguar Land Rover approved diagnostic equipment, calibrate the suspension ride height.
scientia non olet · About LEMON Manuals