LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2021 >> Range Rover Evoque R-Dynamic S >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Vehicle Dynamic Suspension -- Range Rover EVOQUE/L551 >> Vehicle Dynamic Suspension >> Removal And Installation >> Front Suspension Height Sensor (G2297997) >> Installation

Front Suspension Height Sensor (G2297997): Installation

    • Install the suspension height sensor to the bracket.
    • Install and tighten the 2 screws.

      Torque  : 3 Nm 

    • Install the suspension height sensor to the vehicle.
    • Install and tighten the bolt.

      Torque  : 9 Nm 

  3. Connect the suspension height sensor link.
  4. Connect the electrical connector.
  5. Install the engine undershield.

    Refer to: ENGINE UNDERSHIELD .

  6. Using the Jaguar Land Rover approved diagnostic equipment, calibrate the suspension ride height.

    General Equipment: Jaguar Land Rover approved diagnostic equipment 

scientia non olet · About LEMON Manuals