LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2021 >> Range Rover Evoque R-Dynamic S >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Vehicle Dynamic Suspension -- Range Rover EVOQUE/L551 >> Vehicle Dynamic Suspension >> Removal And Installation >> Chassis Control Module (G2312324) >> Installation

Chassis Control Module (G2312324): Installation

    • Install the chassis control module.
    • Install and tighten the 3 nuts.

      Torque  : 6 Nm 

    • Connect the 4 electrical connectors.
    • Install the noise, vibration and harshness material.
    • Reposition the deployable tow bar speaker.
  3. Install the left loadspace side trim panel.

    Refer to: LEFT LOADSPACE SIDE TRIM PANEL .

  4. Connect the startup battery ground cable.

    Refer to: 12V SYSTEM DISCONNECT .

  5. Using the Jaguar Land Rover approved diagnostic equipment, calibrate the chassis control module.
scientia non olet · About LEMON Manuals