Starter Motor (G2298661): Installation
-
- Install the starter motor.
- Install and tighten the 2 bolts.
Torque : 48 Nm
-
- Reposition the wiring harness.
- Install the wiring harness clip.
- Install and tighten the nut.
Torque : 7 Nm
-
- Reposition the wiring harness.
- Install the wiring harness clip.
- Install and tighten the nut.
Torque : 10 Nm
- Install the cover.
- Install the engine undershield.
Refer to: ENGINE UNDERSHIELD .
- Connect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT .