Flex Fuel Sensor (G2308995): Installation

- Install the flex fuel sensor.
- Install and tighten the 2 nuts.
  Torque : 6 Nm
- Connect the electrical connector.
- Connect the 2 fuel pipes.
- Install the 8 retainers.
- Install and tighten the 4 nuts.
  Torque : 10 Nm
- Install and tighten the 7 bolts.
  Torque : 10 Nm
- Install the right undershield.
Connect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT .
Start the engine and allow to idle for 2 minutes.