LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2021 >> Range Rover Evoque R-Dynamic S >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling - INGENIUM I4 2.0L Petrol -- Range Rover EVOQUE/L551 >> Engine Cooling - INGENIUM I4 2.0L Petrol >> Removal And Installation >> Electric Cooling Fan And Shroud (G2308096) >> Removal

Electric Cooling Fan And Shroud (G2308096): Removal

WARNING: Cooling fans may continue to operate after the engine is turned off. They may also start to operate after the engine is turned off and continue operating for up to 10 minutes.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: JACKING AND LIFTING .

  2. Disconnect the startup battery ground cable.

    Refer to: 12V SYSTEM DISCONNECT .

  3. Remove the cooling module.

    Refer to: COOLING MODULE .

  4. G14450588Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Remove the electric cooling fan and shroud.