Tailgate Wiring Harness (G2318733): Removal

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Disconnect the 12 V system.
Refer to: 12V SYSTEM DISCONNECT .
Remove the tailgate window.
Refer to: TAILGATE WINDOW .
Remove the left D pillar.
Refer to: D-PILLAR TRIM PANEL .
Remove the right D pillar.
Refer to: D-PILLAR TRIM PANEL .
Remove the left loadspace trim panel.
Refer to: LEFT LOADSPACE SIDE TRIM PANEL .
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the electrical connector.
- Remove the 2 ground bolts.
- Release the clip.
- Release the grommet.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the 2 electrical connectors.
- Disconnect the 2 rear window washer hoses.
- Release the 2 clips.
- Release the grommet.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the 4 electrical connectors.
- Disconnect the rear proximity camera washer hose.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the 2 electrical connectors.
- Release the 4 clips.
- Release the grommet.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the grommet.
- Remove the wiring harness.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the 4 clips.
- Release the 2 grommets.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the grommet.
- Release the wiring harness.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the 16 wiring harness clips.
- Release the 3 grommets.
- Remove the wiring harness.