Rear SUBFRAME Link Harness - INGENIUM I3 1.5L Petrol, Vehicles With: PHEV (G2408993): Installation

- Install the rear subframe wiring harness.
- Install the 8 wiring harness grommets.
- Install the 17 wiring harness clips.
- Connect the brake pad wear sensor electrical connector.
- Connect the 2 wheel speed sensor electrical connectors.
- Connect the suspension height sensor electrical connector.
Install the eRAD .
Refer to: ELECTRIC REAR AXLE DRIVE .
WARNING: JLR EVAP trained technicians only.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Power Up the HV system. Only technicians qualified to EVAP level or higher are allowed to complete this step of the procedure.

Refer to: PHEV POWER DOWN/UP - COMPLETE VEHICLE .