Battery Monitoring System Fusible Link
NOTE:
Under no circumstances is a piece of standard wire to be used to effect the fusible link repair.
The BMS fusible link must be replaced, repairs are not to be performed on the fusible link.
If the fusible link ruptures then the source of the fault must be diagnosed and rectified first. The fusible link is then to be replaced using the authorized service repair kit (part number LR057241). The fusible link must be spliced into the affected lead/circuit using the approved sealed inline splice repair technique. See section 4 wire only repair procedure.
Refer to the Electronic Parts Catalogue (EPC) for available components. Stock check required.