Brake Pads - Vehicles With: PHEV (G2740581): Removal

WARNING:

If the brake pad wear warning light has been activated, a new brake pad wear sensor must be installed.
Brake pads must be renewed in axle sets only. Failure to follow this instruction may result in braking efficiency being impaired.

CAUTION:

As the piston is pushed back into the caliper housing, the brake fluid level in the reservoir will rise. Do not allow the reservoir to overflow.
If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water.

NOTE:

This procedure contains illustrations showing certain components removed to provide extra clarity.
This procedure contains some variation in the illustration depending on the vehicle specification, but essential information is always correct.

- Use the Jaguar Land Rover (JLR) approved diagnostic equipment to activate the Integrated Power Brake assembly mode.
  General Equipment: Jaguar Land Rover approved diagnostic equipment
- Set the Electric Park Brake (EPB) to the maintenance position.
  General Equipment: Jaguar Land Rover approved diagnostic equipment
Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING .
Remove the rear wheels and tires.
Refer to: WHEEL AND TIRE .
NOTE: Right side only.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect and release the brake pad wear sensor.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the anti-rattle spring.
- Disconnect and release the electrical connector from the EPB .
- Remove the 2 dust caps.
- Remove the 2 caliper guide pins from the brake caliper.
- Use a suitable tie strap to secure the caliper to one side.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the anti-rattle spring.
- Remove the rear brake pads.