Brake Pads (G2309417): Removal
WARNING:
- If the brake pad wear warning light has been activated, a new brake pad wear sensor must be installed.
- Brake pads must be renewed in axle sets only. Failure to follow this instruction may result in braking efficiency being impaired.
CAUTION:
If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water.
NOTE:
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- This procedure contains some variation in the illustration depending on the vehicle specification, but essential information is always correct.
- Connect the Jaguar Land Rover (JLR) approved diagnostic equipment and set Electric Park Brake (EPB) to the maintenance position.
General Equipment: Jaguar Land Rover approved diagnostic equipment
-
NOTE: This step is only required if the diagnostic tool is not available.
Activate the service mode of the EPB.
Refer to: ELECTRIC PARK BRAKE SERVICE MODE ACTIVATION AND DEACTIVATION .
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING .
- Remove the rear wheels and tires.
Refer to: WHEEL AND TIRE .
-
NOTE: Right hand side only.
Disconnect and release the brake pad wear sensor.
- Remove the anti-rattle spring.
- Disconnect and release the EPB electrical connector.
- Remove the 2 dust caps.
- Remove the 2 caliper guide pins.
- Using a suitable tie strap, secure the caliper to one side.
-
NOTE: Note the orientation of the anti-rattle spring prior to removal.
- Remove the anti-rattle spring.
- Remove the rear brake pads.