Brake Disc - Vehicles With: PHEV (G2740580): Removal

WARNING:

If new brake discs are to be installed, make sure that new brake pads are installed.
Brake discs must be replaced in axle sets.

CAUTION:

The brake disc can be easily damaged. Do not drop the brake disc.
Make sure the brake disc is held only on the friction ring during operation.
Make sure to discard the component if the brake disc got any accidental hit, impact or damage on the surface during handling.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

- Use the Jaguar Land Rover (JLR) approved diagnostic equipment to activate the Integrated Power Brake assembly mode.
  General Equipment: Jaguar Land Rover approved diagnostic equipment
- Set the Electric Park Brake (EPB) to the maintenance position.
  General Equipment: Jaguar Land Rover approved diagnostic equipment
Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING .
Remove the rear wheel and tire.
Refer to: WHEEL AND TIRE .
NOTE: Right side only.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect and release the brake pad wear sensor.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect and release the EPB electrical connector.
- Remove and discard the 2 bolts.
- Using a suitable tie strap, secure the brake caliper to one side.
CAUTION: The brake disc can be easily damaged. Do not drop the brake disc.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the and discard the screw.
- Remove the brake disc.