Brake Caliper Anchor Plate (G2309414): Installation

WARNING: Do not use compressed air to clean brake components. Dust from friction materials can be harmful if inhaled.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Clean the brake caliper housing and anchor plate using brake cleaning fluid.

Material: Brake Cleaner (3U7J-2C410-AA)
CAUTION: Damaged components must be replaced.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Inspect the caliper piston and slide pin seals for damage.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the brake caliper anchor plate.
- Install and tighten the 2 bolts.
  Renew Part: Brake caliper carrier bolt(s) Quantity: 2 .
  
  Torque : 110 Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the rear brake pads.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the brake caliper.
- Install the brake caliper guide pins.
  Torque : 30 Nm
- Install the 2 dust caps.
- Connect the Electric Park Brake (EPB) actuator electrical connector.
- Install the anti-rattle spring.
NOTE: Right hand side only.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Connect and secure the brake pad wear sensor.
Calibrate the EPB using the Jaguar Land Rover (JLR) approved diagnostic equipment.
General Equipment: Jaguar Land Rover approved diagnostic equipment
NOTE: This step is only required if the Jaguar Land Rover (JLR) approved diagnostic equipment is not available.

Deactivate the service mode function of the EPB.

Refer to: ELECTRIC PARK BRAKE SERVICE MODE ACTIVATION AND DEACTIVATION .