Brake Caliper - Vehicles With: PHEV (G2740567): Installation

NOTE: Only do this step if a new component is to be installed.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the new O-ring seal.
  Renew Part: Electric park brake actuator fitting kit Quantity: 1 .
- Install the EPB actuator.
- Install and tighten the 2 new bolts.
  Torque : 11 Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Clean the brake caliper carrier using brake cleaning fluid.

Material: Brake Cleaner ()
WARNING: Damaged components must be replaced.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Inspect the caliper piston and slide pin seals for damage.
- NOTE: Make sure that the brake hose is installed in the correct orientation.
  
  Install the new brake hose to the body bracket.
  
  Renew Part: Brake hose Quantity: 1 .
- Install the retaining clip.
- Connect and tighten the brake pipe union.
  Torque : 15.5 Nm
- Install and tighten the brake hose retaining bracket nut.
  Torque : 10 Nm
- Install the brake caliper.
- Install the 2 brake caliper slide pins.
  Torque : 30 Nm
- Install the 2 dust caps.
- Connect the brake hose to the brake caliper.
  Torque : 35 Nm
- Install the anti-rattle spring.
- NOTE: Right side only.
  
  Connect and secure the brake pad wear sensor to the brake pad.
- Connect and secure the EPB actuator electrical connector.
Install the rear wheel arch liner.
Refer to: REAR WHEEL ARCH LINER .
Bleed the brake system.
Refer to: BRAKE SYSTEM PRESSURE BLEEDING - VEHICLES WITH: PHEV .
Install the wheel and tire assembly.
Refer to: WHEEL AND TIRE .
Use the JLR approved diagnostic equipment to deactivate the Integrated Power Brake Assembly mode.
General Equipment: Jaguar Land Rover approved diagnostic equipment
Remove the EPB from maintenance position.
General Equipment: Jaguar Land Rover approved diagnostic equipment