Brake Caliper (G2309700): Removal

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Connect the Jaguar Land Rover (JLR) approved diagnostic equipment and set the Electric Park Brake (EPB) to the maintenance position.
General Equipment: Jaguar Land Rover approved diagnostic equipment
NOTE: This step is only required if the JLR approved diagnostic equipment is not available.

Activate the service mode function of the EPB .

Refer to: ELECTRIC PARK BRAKE SERVICE MODE ACTIVATION AND DEACTIVATION .
Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING .
Remove the rear wheel and tire assembly.
Refer to: WHEEL AND TIRE .
Remove the rear wheel arch liner.
Refer to: REAR WHEEL ARCH LINER .
NOTE: Right side only.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect and release the brake pad wear sensor.
NOTE: Note the orientation of the brake hose.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect and release the EPB actuator electrical connector.
- Disconnect the brake pipe union.
- Remove the brake hose bracket retaining nut and banjo bolt.
- Remove the retaining clip.
- Remove and discard the brake hose.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 2 dust caps.
- Remove the 2 brake caliper slide pins.
- Remove the brake caliper.
NOTE: Only do this step if a new component is to be installed.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove and discard the 2 bolts.
- Remove the EPB actuator.
- Remove and discard the O-ring seal.