Brake Master Cylinder - Left Hand Drive (G2309371): Installation

The following step(s) applies to:

All vehicles

CAUTION:
- Make sure that new seals are installed.
- Make sure that new nuts are installed.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the 3 new seals.
  Renew Part: Brake master cylinder nuts and seal kit Quantity: 1 .
- Install the brake master cylinder.
- Install and tighten the 2 new nuts.
  Torque : 25 Nm
- Connect the 2 brake pipe unions.
  Torque : 17, 5 Nm
CAUTION: Make sure that the brake fluid reservoir is correctly seated to the brake master cylinder seals.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the brake fluid reservoir.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install and tighten the screw.
  Torque : 7 Nm
- Connect the electrical connector.
- Carefully secure the clip.
The following step(s) applies to:

Vehicles with automatic transmission
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Carefully secure the clip.

The following step(s) applies to:

Vehicles with manual transmission
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Carefully secure the clip.
- Connect the clutch master cylinder supply line.
The following step(s) applies to:

All vehicles
- Position the secondary bulkhead panel assembly to the original position.
- Install and tighten the 5 bolts.
  Torque : 7 Nm
CAUTION: Brake fluid will damage paint finished surfaces. If spilled, immediately remove the fluid and clean the area with water.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Fill the brake fluid reservoir with the correct amount of brake fluid.
  Refer to: SPECIFICATIONS .
- Install the brake fluid reservoir cap.
Install the startup battery tray.
Refer to: STARTUP BATTERY TRAY .
Bleed the brake system.
Refer to: BRAKE SYSTEM PRESSURE BLEEDING - VEHICLES WITH: MHEV/NON-ELECTRIC VEHICLES .

The following step(s) applies to:

Vehicles with manual transmission
Bleed the clutch system.
Refer to: CLUTCH SYSTEM BLEEDING .