Integrated Power Brake Sleep Cycle - [+] PHEV (G2882431): Initialization

Make sure all vehicle electrical accessories are switched OFF.
Remove the battery support unit connected to the vehicle.
Remove the Jaguar Land Rover (JLR) diagnostic equipment connected to the vehicle.
Make sure the transmission selector is in the PARK position and the Electric Park Brake (EPB) is applied.
- Close doors/windows/apertures as follows:
- Fully close hood/tailgate/luggage compartment lid/open roof panel(s).
- Make sure ALL vehicle windows are closed to full extent.
- Close all doors EXCEPT the passenger front door (this must remain open to gain access to the vehicle).
- NOTE: Do not start the vehicle during this step.
  
  With the Smart Key in your hand.
- Enter the vehicle through the passenger front door and select the Ignition ON (Power Mode 6).
- Wait a few seconds for the instrument panel cluster warning indicators to stabilize.
- With the vehicle unlocked and Smart Key inside, press the START button again to select Accessory mode (Power Mode 4).
With the Smart Key in your hand, exit the vehicle.
Keep the passenger front door open and lock the passenger front door latch using a suitable tool (the vehicle monitoring systems will now see the passenger front door as closed. This will allow re-entry to the vehicle to monitor the Hazard Warning Light Switch back light status).
Press the lock button on the Smart Key to lock the vehicle (single press only to avoid volumetric sensor arming).
NOTE: DO NOT operate any switches/controls when re-entering the vehicle.

Wait for the vehicle systems to go to sleep and shut down. The Hazard Warning Light Switch back light will extinguish when the vehicle systems have gone to sleep.
When the Hazard Warning Light Switch back light has full extinguished, wait a further 11 minutes (minimum) for the integrated power brake to complete its sleep cycle.