Rear Bumper (G2299906): Installation

NOTE: Make sure that all the clips are correctly installed.
- Install the rear valance.
- Install and tighten the 6 screws.
- Install the 4 parking aid sensors.
- Install the 2 park assist sensors.
- Install the hands-free tailgate sensor assemblies.
- Install and tighten the 6 screws.
  Torque : 5 Nm
- Install the rear fog lamps.
- Install and tighten the 4 screws.
  Torque : 4.5 Nm
NOTE: Make sure that all the clips are correctly installed.
- Install the wiring harness to the rear bumper.
- Connect the 10 electrical connectors.
CAUTION: Care must be taken to avoid damaging the surrounding paintwork.

NOTE: Make sure that all the clips are correctly installed.
- With assistance, install the rear bumper.
- Secure the rear bumper on both sides.
- Install the 2 cover caps.
- Install and tighten the 2 bolts to the inside of the rear bumper.
  Torque : 2.5 Nm
- Install the 2 quarter panel finishers on both sides.
- Install the tailgate weatherstrip.
Install and tighten the 2 lower screws to the rear bumper.
Install and tighten the 2 bolts on both sides of the rear bumper.
NOTE: Left side only.

Connect the electrical connector to the rear bumper wiring harness.
- Install the rear wheel arch liner mouldings on both sides.
- Install and tighten the 2 bolts.
- Install and tighten the 4 screws.
- Install the rear wheel arch liners on both sides.
- Install and tighten the 6 screws.
- Install and tighten the 2 nuts.
NOTE: Repeat the procedure for the other side.

Install the wheel and tire.

Refer to: WHEEL AND TIRE .