Fuel Tank - INGENIUM I4 2.0L Petrol - PHEV (G2173094): Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: With assistance install the component.
- Using a suitable stand, install the fuel tank and the 6 retaining bolts.
  General Equipment: Transmission jack
  
  Torque : 47.5Nm
Secure the fuel filler neck to the fuel tank.
Install the onboard control module cover and the 6 retaining bolts.
Torque : 12Nm
Install the fuel tank heatshield and the 8 retaining bolts.
Torque : 10Nm
Install the rear driveshaft.
Refer to: REAR DRIVESHAFT - INGENIUM I4 2.0L PETROL/INGENIUM I4 2.0L PETROL - PHEV .
NOTE: Illustration shows right side, left side similar.

Install the left side and the right side undershields.
NOTE: Repeat the procedure for the other side.

Install the rear rocker panel moulding.

Refer to: REAR ROCKER PANEL MOULDING - [+] STANDARD WHEELBASE .
Refill the fuel tank.
Bleed the low pressure fuel system.
Refer to: LOW-PRESSURE FUEL SYSTEM BLEEDING .