Fuel Level Sensor - INGENIUM I4 2.0L Petrol - PHEV (G2156333): Removal
WARNING: This page is about a different variant/trim than selected.
WARNING:
- Wait for a minimum of 1 minute after the engine has stopped before carrying out any repair to the fuel injection system.
- Avoid flames, sparks or lighted substances.
- Place the vehicle in a well ventilated, quarantined area and arrange ' No Smoking/Petrol Fumes' signs about the vehicle.
CAUTION:
Before disconnecting or removing components, make sure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.
NOTE:
- Some variation in the illustrations may occur, but the essential information is always correct.
- Some components shown removed for clarity.
- Removal steps in this procedure may contain installation details.
- Disconnect the battery ground cable.
Refer to: SPECIFICATIONS .
- Refer to: FUEL PUMP DRIVER MODULE
-
CAUTION: Take extra care not to damage the fuel tank level sensor float and arm