LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2021 >> Range Rover Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 47 (Engine - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol PHEV -- Range Rover/L405 (1 Of 2)) >> Engine - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV (G2412677) >> Removal And Installation >> Valves (G2226081) >> Installation

Valves (G2226081): Installation

WARNING: This page is about a different variant/trim than selected.
  1. G12004528Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    1. Apply a small amount of fine grinding paste to the face of the valve.
    2. Install the valve into the cylinder head valve guide.
    3. Using a suitable tool, lap in the valve until a continuous mark is visible on both the valve and the valve seat.
    4. Remove the valve and clean off all the grinding paste from the valve and the valve seat.
  2. Install a new valve stem seal.

    Renew Part: Valve stem oil seals  Quantity: 1  .

  3. Lubricate the valve stem with clean engine oil.
  4. Install the valve into the cylinder head valve guide.
  5. Install the valve spring and cap.
  6. Using the special tool, install the valve spring retaining collets.
  7. Repeat the installation procedure for the remaining valves.
  8. Install the cylinder head.

    Refer to: CYLINDER HEAD .

  9. G12528295Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Power Up the High Voltage (HV) system. Only technicians qualified to EVAP level are allowed to perform this procedure. It is mandated that all technicians involved with the steps in this procedure have read and understood the Electric Vehicle Safety Rules.

    Refer to: HYBRID ELECTRIC VEHICLE POWER DOWN/UP .

scientia non olet · About LEMON Manuals