Right Engine Mount - INGENIUM I4 2.0L Petrol (G2173212): Installation
WARNING: This page is about a different variant/trim than selected.
- Install the engine mount.
- Install and tighten 4 new engine mounting to subframe bolts.
Renew Part: Engine mounting bracket to subframe bolts Quantity: 4 .
Torque : 32Nm
- Lower the vehicle jack until the bracket rests on the engine mounting.
General Equipment: Trolley jack
- Install and tighten a new engine mount bracket to engine mount nut.
Renew Part: Engine mount to engine mount bracket nut Quantity: 1 .
Torque : 124Nm
- Remove the hydraulic jack from under the vehicle.
General Equipment: Hydraulic floor jacks (2 tonnes minimum capacity)
- Connect the vacuum pipe to the engine mounting.
- Install the engine undershield.
Refer to: ENGINE UNDERSHIELD .