Crankshaft Front Seal - INGENIUM I4 2.0L Petrol - PHEV (G2173075): Removal

WARNING: This page is about a different variant/trim than selected.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING .
Disconnect the startup battery ground cable.
Refer to: SPECIFICATIONS .
Remove the crankshaft pulley.
Refer to: CRANKSHAFT PULLEY - INGENIUM I4 2.0L PETROL - PHEV .
NOTE: Using the special tool, remove the oil seal.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove and discard the seal.
  Special Tool(s): JLR-303-1628