LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2021 >> Range Rover Base >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel System - General Information -- Range Rover/L405 >> Fuel System - General Information (G1509633) >> General Procedures >> High-Pressure Fuel System Bleeding (G1509629)

High-Pressure Fuel System Bleeding (G1509629)

19.50.24 FUEL SYSTEM BLEED - HIGH PRESSURE ALL DERIVATIVES 0.10
WARNING:
  • Do not carry out any repairs to the fuel system with the engine running. The fuel pressure within the system can be as high as 1650 bar (23, 931 lb-sq-in). Failure to follow this instruction may result in personal injury.
  • Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable vapors are always present and may ignite. Failure to follow these instructions may result in personal injury.
  • If fuel contacts the eyes, flush the eyes with cold water or eyewash solution and seek immediate medical attention.
  • If fuel contacts the eyes, flush the eyes with cold water or eyewash solution and seek immediate medical attention.
  • Wait at least 30 seconds after the engine stops before commencing any repair to the high-pressure fuel injection system. Failure to follow this instruction may result in personal injury.
  • Wash hands thoroughly after fuel handling, as prolonged contact may cause irritation. Should irritation develop, seek medical attention.
  • Do not carry or operate cellular phones when working on or near any fuel related components. Highly flammable vapors are always present and may ignite. Failure to follow these instructions may result in personal injury.
CAUTION:
  • Make sure that any protective clothing worn is clean and made from lint-free non-flocking material.
  • Make sure the workshop area in which the vehicle is being worked on is as clean and as dust free as possible. Foreign matter from work on clutches, brakes or from machining or welding operations can contaminate the fuel system and may result in later malfunction.
  1. Set the ignition to the ON position.
  2. CAUTION: Do not crank the engine for more than 20 seconds.

    Start the engine.

  3. NOTE: If the engine does not start, wait for 5 seconds and repeat step 2.

    Set the ignition to the OFF position.

scientia non olet · About LEMON Manuals