Front Brake Hose (G2416911): Removal

CAUTION: If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water.

NOTE: This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING .
Remove the wheel and tire.
Refer to: WHEEL AND TIRE .
CAUTION: The brake pad wear sensor, which is installed on the left side only, is easily damaged. Do not use excessive force to release the lead.

NOTE: Make a note of the routed position of the wiring harness prior to removal.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the wheel speed sensor lead.
- Release the brake pad wear sensor wiring harness.
- Remove the wiring harness bracket from the wheel knuckle.
WARNING: Fluid loss is unavoidable, use absorbent cloth or a container to collect the fluid.
CAUTION:
- If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water.
- Discard the nut.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the brake pipe.
- Remove and discard the nut.
- Remove the retaining clip.
WARNING: Fluid loss is unavoidable, use absorbent cloth or a container to collect the fluid.

CAUTION: If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 2 bolts.
- Remove and discard the brake hose.