Instrument Panel Upper Section (G1951664): Removal
WARNING:
- Do not probe supplemental restraint system (SRS) electrical connectors.
- To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or replacing any air bag supplementary restraints system (SRS) components. To deplete the backup power supply energy, disconnect the battery ground cable and wait for one minute. Failure to follow this instruction may result in personal injury.
NOTE:
- Removal steps in this procedure may contain installation details.
- Some variation in the illustrations may occur, but the essential information is always correct.
- Some components shown in illustration, removed for clarity.
- Make sure only a suitable plastic tool is used.
- Disconnect the battery ground cable.
Refer to: SPECIFICATIONS .
- Refer to: UPPER GLOVEBOX .
- Refer to: LOWER GLOVEBOX .
- Refer to: FRONT PORTABLE MEDIA INTERFACE PANEL .
- Refer to: DIGITAL DISC PLAYER .
- Refer to: FLOOR CONSOLE .
-
NOTE: Repeat the procedure for the other side.
-
NOTE: Repeat the procedure for the other side.
Torque : 6Nm
Torque : 1.7Nm
Torque : 1.7Nm
Torque : 1.7Nm
Torque : 1.7Nm
Torque : 1.7Nm
Torque
M6: 9Nm
M6: 2.5Nm
Torque : 9Nm
Torque : 9Nm
Torque : 9Nm
Torque : 1.7Nm
Torque : 9Nm
Torque : 9Nm
-
WARNING: This step requires the aid of another technician.NOTE: Do not disassemble further if the component is removed for access only.
-
NOTE: Do not disassemble further if the component is removed for access only.
Torque : 1.7Nm
Torque : 1.7Nm
Torque : 1.5Nm
Torque : 1.5Nm
Torque : 5Nm
Torque : 4.5Nm
Torque : 9Nm