Instrument Cluster (G1577065): Removal

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.
When a new instrument cluster is to be installed, the Land Rover approved diagnostic system must be connected to the vehicle and the instrument cluster renewal procedure followed.
19MY onward and non-NAS markets only - if a new instrument cluster is to be installed, a new Remote Function Actuator (RFA) may be required. All vehicle keys must be presented to complete the RFA renewal.

CAUTION: If the software number is K8D2-14C104-AC or L8B2-14C104-AC, a new RFA will be required.
NOTE:
- This step is only applicable to 19MY onward vehicles.
- Non-NAS Markets only.
Using the Land Rover diagnostic equipment, read the RFA software number.

General Equipment: Land Rover diagnostic equipment
CAUTION: Apply heatshrink or protective tape to the end of a suitable tool to protect the interior components.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Disconnect the battery ground cable.
Refer to: SPECIFICATIONS .
NOTE: Release the trim clips from the middle to the sides, failure to follow this instruction may result in damage to the retaining frame.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
NOTE: The steering wheel is shown in illustration, removed for clarity.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque : 1.7Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
NOTE: The steering wheel is shown in illustration, removed for clarity.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Torque
  Upper screws (1): 1.1Nm
  
  Lower screws (1): 1.7Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC