Block Heater (G2201218): Removal
NOTE:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING .
- Disconnect the startup battery ground cable.
Refer to: SPECIFICATIONS .
- Partially drain the cooling system.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING .
- Remove the thermostat housing.
Refer to: THERMOSTAT HOUSING .
- Disconnect the electrical connector.
- Inspect the seal. Replace if damaged.
Remove the block heater.