Electric Park Brake Release When The Vehicle Has No Electrical Power (G1947453): Check

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.
Left side illustrations shown, Right side is similar.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING
Remove the 2 rear wheels and tires.
Refer to: WHEEL AND TIRE
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the electrical connector from the Electric Park Brake (EPB) actuator.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove and discard the 2 bolts.
- Remove the EPB actuator.
- Remove and discard the O-ring seal.
CAUTION: The piston must only be released far enough to release the clamping force on the brake disc.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Use a suitable tool to release the piston as illustrated.
Repeat steps 3 to 5 for the other side.