Brake Pads - Vehicles With: 365 Mm Brake Disc (G2312489): Removal
WARNING:
- Brake pads must be renewed in axle sets only. Failure to follow this instruction may result in braking efficiency being impaired.
- If the brake pad wear warning light has been activated, a new brake pad wear sensor must be installed.
NOTE:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- If this component is being renewed because of a customer complaint, make sure to follow the brake system Diagnosis and Testing procedure.
Refer to: BRAKE SYSTEM (G2474292)
- Connect the Jaguar Land Rover approved diagnostic equipment and set the Electric Park Brake (EPB) to the maintenance position.
General Equipment: Jaguar Land Rover approved diagnostic equipment
-
NOTE: This step is only required if the Jaguar Land Rover approved diagnostic equipment is not available.
Release the EPB.
Refer to: ELECTRIC PARK BRAKE SERVICE MODE ACTIVATION AND DEACTIVATION .
-
NOTE: This step is only required if the vehicle has no startup power.
Release the EPB.
Refer to: ELECTRIC PARK BRAKE RELEASE WHEN THE VEHICLE HAS NO ELECTRICAL POWER .
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING .
- Remove the wheel and tire.
Refer to: WHEEL AND TIRE .
-
CAUTION: The brake pad wear indicator sensor is easily damaged. Do not use a lever to remove the sensor. Use fingers only.NOTE: Right side only.
Inspect the brake pad wear sensor for signs of wear or damage. Install a new sensor if necessary.
-
CAUTION: Do not allow the brake caliper to hang on the brake hose.
- Disconnect the EPB.
- Remove the 2 retaining bolts.
- Remove the brake caliper.
- Remove the brake pads.
- Remove the 2 anti-rattle springs.
- Repeat the above procedure for the other side.