Brake Vacuum Pump - INGENIUM I4 2.0L Diesel (G1961669): Removal

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING
Disconnect the startup battery ground cable.
Refer to: SPECIFICATIONS
Remove the oil pump chain.
Refer to the appropriate service information
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the electrical connector for the oil pump.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Release the oil pump wiring harness.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the brake vacuum pump assembly.
NOTE: Do not disassemble further if the component is removed for access only.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the oil pick-up pipe.