Brake Vacuum Pump - INGENIUM I4 2.0L Diesel (G1961669): Installation

NOTE: Only carry out this step if previously removed.

Install the oil pick-up pipe and tighten the bolts to the correct torque.

Torque : 12 Nm
Install the brake vacuum pump assembly and tighten the bolts to the correct torque.
Torque : 25 Nm
Install the oil pump wiring harness.
Connect the electrical connector for the oil pump.
Install the oil pump chain.
Refer to the appropriate service information
Connect the startup battery ground cable.
Refer to: SPECIFICATIONS