Brake Booster - RHD (G1977390): Removal

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Remove the right side secondary bulkhead panel.
Refer to: SECONDARY BULKHEAD RIGHT PANEL
Remove the brake master cylinder.
Refer to: BRAKE MASTER CYLINDER
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the drivers side closing trim panel.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the interior light electrical connector.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the retaining pin.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the 4 securing nuts.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the electrical connector.
CAUTION: Before removing the component, make sure the surrounding area is clean and dry to prevent contamination entering the brake vacuum system.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the brake vacuum pressure sensor.
CAUTION:
- Do not use excessive force to move the component. Make sure that all fixings are fully released.
- Care must be taken not to damage the brake pipe during this step.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Position the brake pipes to allow access to the brake booster.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the brake booster.