Front Brake Hose (G2309501): Removal

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING .
Remove the wheel and tire.
Refer to: WHEEL AND TIRE .
CAUTION: The brake pad wear sensor, which is installed on the left hand side only, is easily damaged. Do not use excessive force to release the lead.

NOTE: Make a note of the routed position of the wiring harness prior to removal.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the wheel speed sensor lead.
- Release the brake pad wear sensor wiring harness.
- Remove the wiring harness bracket from the wheel knuckle.
CAUTION: The brake pad wear sensor, which is installed on the left hand side only, is easily damaged. Do not use excessive force to release the lead.

NOTE: Make a note of the routed position of the wiring harness prior to removal.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the wheel speed sensor lead.
- Release the brake pad wear sensor wiring harness.
WARNING: Fluid loss is unavoidable, use absorbent cloth or a container to collect the fluid.

CAUTION: If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the brake pipe.
- Remove and discard the nut.
- Remove the retaining clip.
WARNING: Fluid loss is unavoidable, use absorbent cloth or a container to collect the fluid.

CAUTION: If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 2 bolts.
- Remove and discard the brake hose.