Block Heater (G1763050): Installation

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the block heater.

Torque : 50 Nm
CAUTION: Protect the surrounding paintwork and body.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Mark the front bumper cover, using the dimensions illustrated.
CAUTION: Protect the surrounding paintwork and body.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using a suitable tool, cut a 26 mm hole in the front bumper cover.
NOTE: Note the orientation of the clips prior to removal.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the retaining clips from the block heater wiring harness.
Feed the block heater wiring harness through the hole in the front bumper cover.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Tighten the block heater wiring harness to front bumper cover retaining nut.
NOTE: Make sure that the retaining clips are installed to the noted orientation on the removal.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the retaining clips to the block heater wiring harness.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Feed the block heater wiring harness through the front panel at the area indicated.
Refer to: FRONT BUMPER .
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Secure the block heater wiring harness.
Feed the block heater wiring harness over the front differential.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Secure the block heater wiring harness.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque : 10 Nm
CAUTION: Make sure the block heater wiring harness is secure and does not obstruct any moving components.

Check alignment of block heater wiring harness.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING .
Refer to: FRONT DRIVESHAFT - V6 S/C 3.0L PETROL .
Test the system for correct operation.