Brake Caliper - Vehicles With: 365 Mm Brake Disc (G2312488): Installation
Install the Electric Park Brake (EPB) actuator.
Renew Part: Electric park brake actuator fitting kit Quantity: 1 .
Torque : 12 Nm
- Install the brake caliper.
- Install the 2 retaining bolts.
Torque : 35 Nm
- Connect the EPB.
- Install a new brake hose.
Renew Part: Brake hose Quantity: 1 .
Torque : 16 Nm
- Install the retaining bolt.
Torque : 16 Nm
- Install a new brake hose.
Install the banjo bolt.
Torque : 32 Nm
-
NOTE: Right hand side only.
Install the brake pad wear sensor.
- Bleed the brake system.
Refer to: BRAKE SYSTEM BLEEDING FIXED CALIPER .
- Install the wheel and tire.
Refer to: WHEEL AND TIRE (G2469592)
- Using the Jaguar Land Rover approved diagnostics equipment, calibrate the EPB.
General Equipment: Jaguar Land Rover approved diagnostic equipment
-
NOTE: This step is only required if the diagnostic equipment is not available.
Deactivate the service mode function of the EPB.
Refer to: ELECTRIC PARK BRAKE SERVICE MODE ACTIVATION AND DEACTIVATION .