Front Brake Hose (G2309501): Installation

CAUTION: Make sure that the brake hose is not twisted and is correctly located.
- Install the brake hose.
  Renew Part: Brake hose Quantity: 1 .
- Install the 2 bolts.
  Torque
  
  M8 bolt: 9 Nm
  
  Banjo bolt: 32 Nm
WARNING: Make sure that a new nut is installed.
- Connect the brake pipe union.
  Torque : 15 Nm
- Install a new nut.
  Renew Part: Stabilizer bar link upper nut Quantity: 1 .
  
  Torque : 185 Nm
- Install the retaining clip.
NOTE: Make sure that the harness is routed to the position noted on removal.
- Install the wiring harness bracket to the wheel knuckle.
  Torque
  
  M8 bolt: 24 Nm
  
  M6 bolt: 18 Nm
- Secure the brake pad wear sensor lead.
- Secure the wheel speed sensor lead.
Install the wheel and tire.
Refer to: WHEEL AND TIRE .
Do a brake system bleeding process.
Refer to: BRAKE SYSTEM BLEEDING FIXED CALIPER .

Refer to: BRAKE SYSTEM BLEEDING FLOATING CALIPER .