Head Up Display (G2162230): Installation
-
CAUTION: If a new Head Up Display (HUD) is installed, after fitment make sure that the protection cover is removed from the lens using the protection cover pull tab.
- Install the Head Up Display (HUD).
- Install and tighten the 2 bolts.
Torque : 5 Nm
-
- Install the bracket.
- Install and tighten the 4 bolts.
Torque : 5 Nm
-
- Install the air duct.
- Install and tighten the 2 screws.
Torque : 2.2 Nm
- Install the instrument panel upper trim.
Refer to: INSTRUMENT PANEL UPPER TRIM
- Connect the startup battery ground cable.
Refer to: SPECIFICATIONS
- If a new component has been installed, configure using Land Rover approved diagnostic equipment.
General Equipment: Land Rover diagnostic equipment