Instrument Cluster (G2162229): Installation

- Connect the electrical connector.
- Install the instrument cluster.
- Install and tighten the 4 screws.
  Torque : 1.7 Nm
NOTE: If equipped.
- Connect the 3 electrical connectors.
- Install the 4 harness clips.
- Install the instrument cluster assembly.
- Install and tighten the 4 bolts.
  Torque : 1.7 Nm
Install the instrument cluster surrounding trim.
Install the steering column upper trim cover assembly.
- Install and tighten the 3 screws.
  Torque : 2.2 Nm
- Connect the electrical connector.
- Install and tighten the screw.
  Torque : 2.2 Nm
Install the screw cover.
- Connect the electrical connector.
- Install the instrument panel inner trim panel.
Install the instrument panel outer trim panel.
Connect the startup battery ground cable.
Refer to: SPECIFICATIONS
Reposition the steering column.
CAUTION: Only applicable vehicles with software numbers K8D2-14C104-AC or L8B2-14C104-AC as detailed in removal step 1 .
NOTE:
- Only complete this step if a new instrument cluster is to be installed.
- This step is only applicable to 19MY onward vehicles.
- Non-NAS Markets only.
- SRO must be claimed separately.
Install a new RFA .

Refer to: REMOTE FUNCTION ACTUATOR
NOTE: Only perform this step if a new instrument cluster was installed.

Use the Land Rover approved diagnostic equipment to configure the instrument cluster.

General Equipment: Land Rover diagnostic equipment