Oil Pump - INGENIUM I4 2.0L Petrol (G2344482): Removal

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING
Disconnect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT
Remove the oil pump chain.
Refer to: OIL PUMP DRIVE CHAIN - INGENIUM I4 2.0L PETROL
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the electrical connector.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the wiring harness from the clip.
- Release the electrical connector clip.
- Reposition the electrical connector away from the cylinder block.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the wiring harness from the 2 clips.
- Remove the oil pump intake pipe bolt.
- Remove the 4 oil pump bolts.
- Remove the oil pump.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Inspect the seal and replace if damaged or worn.
NOTE: Do not disassemble further if the component is removed for access only.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 2 bolts.
- Remove the oil pump inlet pipe.