Lower Timing Cover - INGENIUM I4 2.0L Petrol (G2344486): Removal

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING
Disconnect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT
Remove the crankshaft rear seal.
Refer to: CRANKSHAFT REAR SEAL - INGENIUM I4 2.0L PETROL
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Release the clip.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the bolt.
- Release the clip.
- Reposition the Crankshaft Position Sensor (CKP) sensor away from the lower timing cover.
CAUTION: Note the installed position of the component(s) prior to removal.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the 2 bolts.
CAUTION:
- Note the installed position of the component(s) prior to removal.
- Take extra care not to damage the surrounding components.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 14 bolts.
- Remove the lower timing cover.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Use a suitable tool to reposition the 2 dowels as illustrated.