LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2021 >> Defender 90 S >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - INGENIUM 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV -- Defender/L663 (1 Of 2) >> Engine - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV (G2344339) >> Removal And Installation >> Crankshaft Rear Seal - INGENIUM I4 2.0L Petrol (G2344451) >> Installation

Crankshaft Rear Seal - INGENIUM I4 2.0L Petrol (G2344451): Installation

  1. CAUTION: Make sure that the area around the component is clean and free of foreign material.
    G12002073Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Install the special tool.

    Special Tool(s): JLR-303-1674A 

  2. CAUTION:
    • If the seal is removed from the spacer provided, a new seal must be installed.
    • Make sure that the area around the component is clean and free of foreign material.
    NOTE: The component labeled (2) in the illustration is an alignment spacer provided with the new seal.
    G12002074Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Position the new crankshaft oil seal (1) and spacer (2) over special tool JLR-303-1674A. Carefully slide the crankshaft oil seal (1) over the end of the crankshaft and discard the spacer (2).

    Special Tool(s): JLR-303-1674A 

    Renew Part: Crankshaft rear seal Quantity: 1  .

  3. G12002075Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Install the second part of special tool JLR-303-1674A to position the crankshaft oil seal correctly.

      Special Tool(s): JLR-303-1674A 

    • Tighten the bolt until the seal is fully installed and the bolt stops turning.
  4. Install the drive plate.

    Refer to: DRIVE PLATE - INGENIUM I4 2.0L PETROL

  5. Connect the startup battery ground cable.

    Refer to: 12V SYSTEM DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals