Camshaft Carrier (G2392162): Installation

The following step(s) applies to: 

All vehicles 

1. NOTE: This step is only required if previously removed.

   Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

   • Lubricate the components with clean engine oil.
   • Install the intake camshaft to the noted removal position.
   • Install and tighten the 10 bolts in the illustrated sequence.

     Torque  : 11 Nm 

2. NOTE: This step is only required if previously removed.

   Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

   • Lubricate the components with clean engine oil.
   • Install the exhaust camshaft to the noted removal position.
   • Install and tighten the 10 bolts in the illustrated sequence.

     Torque  : 11 Nm 

3. NOTE: This step is only required if previously removed.
   • Install a new O-ring seal to the oil filler pipe.

     Renew Part: Oil fill pipe O-ring seal Quantity: 1  .

   • Install the oil filler pipe.
   • Install and tighten the bolt.

     Torque  : 12 Nm 

4. • Install 2 new O-ring seals to the 2 CMP  .
   • Install the 2 CMP  sensors.
   • Install and tighten the 2 bolts.

     Torque  : 8 Nm 

5. CAUTION: Make sure that the mating surfaces are clean and free from debris and foreign material.

   Install a new camshaft carrier gasket.

   Renew Part: Camshaft carrier gasket Quantity: 1  .

6. CAUTION: Make sure that the mating surfaces are clean and free from debris and foreign material.

   Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

   • Install the camshaft carrier.
   • Install and tighten the 19 bolts in the illustrated sequence.

     Torque  : 10 Nm 

   • Tighten the 19 bolts in the illustrated sequence.

     Torque  : 28 Nm 

7. • Reposition the coolant hose into the correct location.
   • Install and tighten the 2 bolts.

     Torque  : 10 Nm 

8. • Reposition the engine wiring harness into the correct location.
   • Install the 4 clips.
   • Connect the 8 electrical connectors.
   • Install and tighten the 2 bolts.

     Torque  : 6 Nm 

   The following step(s) applies to: 

   Non plug in hybrid electric vehicles only 

9. Install the accessory drive belt.

   Refer to: ACCESSORY DRIVE BELT - INGENIUM I4 2.0L PETROL

   The following step(s) applies to: 

   Plug in Hybrid Electric Vehicles (PHEV) 

10. Install the coolant pump belt.

    Refer to: ACCESSORY DRIVE BELT - INGENIUM I4 2.0L PETROL

    The following step(s) applies to: 

    All vehicles 

11. Install the HP  fuel pump.

    Refer to: HIGH PRESSURE FUEL PUMP

12. Install the evaporative emission canister purge valve.

    Refer to: EVAPORATIVE EMISSION CANISTER PURGE VALVE

13. Install the engine vent oil separator.

    Refer to: ENGINE VENT OIL SEPARATOR

14. Install the fuel injectors.

    Refer to: FUEL INJECTORS

15. Install the Continuous Variable Valve Lift (CVVL) assembly.

    Refer to: CONTINUOUS VARIABLE VALVE LIFT 

16. Install the upper timing chain.

    Refer to: UPPER TIMING CHAIN 

17. Connect the startup battery ground cable.

    Refer to: 12V SYSTEM DISCONNECT AND CONNECT