PHEV Battery Coolant Radiator (G2756435): Removal

WARNING: Injury such as scalding could be caused by escaping steam or coolant. Make sure the vehicle cooling system is cool prior to carrying out this procedure.

CAUTION: Be prepared to collect escaping coolant.

NOTE:

This procedure contains illustrations showing certain components removed to provide extra clarity.
This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.

Disconnect the 12 V system.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT
Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING
WARNING: JLR Electric Vehicle Competent Person (EVCP) trained technicians only.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

This procedure involves work on components associated with the High Voltage (HV) system. Only technicians qualified to EVCP level or higher are allowed to complete this procedure.
Drain the Plug-in Hybrid Electric Vehicle (PHEV) battery cooling system.
Refer to: PHEV BATTERY COOLING SYSTEM DRAINING AND VACUUM FILLING
Remove the front bumper.
Refer to: FRONT BUMPER
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 6 screws.
- Disconnect the electrical connector.
- Remove the lower active grille air shutter.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the 4 retaining clips.
- Release the coolant pipe.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Release the PHEV battery coolant radiator from the 2 left side retaining clips.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Release the PHEV battery coolant radiator from the 2 right side retaining clips.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the 2 coolant pipes.
- Remove the PHEV battery coolant radiator.