MULTIPLATE Clutch

The multiplate clutch comprises an inner drive hub, a clutch basket and set of drive/reaction plates and friction plates.

The friction plates are located on splines on the input shaft and rotate when the input shaft is rotating. The drive/reaction plates are located on splines in the clutch basket which is positively attached to the front drive gear.

The front drive sprocket and clutch basket are located on bearings to allow speed difference relative to the input shaft when no locking torque is applied.

When the vehicle is moving, all the component below rotate:

• Front driveshaft
• Front driveshaft output flange
• Output drive gear
• Front drive gear
• Clutch basket.

Torque is not applied to the front driveshaft until the TCCM  engages the multiplate clutch. The front drive gear is attached to the front output shaft by the drive chain.