Output Shaft Seal - INGENIUM I4 2.0L Diesel/INGENIUM I4 2.0L Petrol/INGENIUM I6 3.0L Diesel/INGENIUM I6 3.0L Petrol/V8 S/C 5.0L Petrol (G2414215): Removal

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING
Remove the transfer case.
Refer to: TRANSFER CASE
CAUTION: Care must be taken to avoid damage to the seal running surface.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Use the special tools to remove the seal.

Special Tool(s): 100-012 , 100-012-01 , 308-375