Input Shaft Oil Seal (G2414214): Removal

NOTE:

This procedure contains illustrations showing certain components removed to provide extra clarity.
This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING
Remove the transmission.
Refer to: TRANSMISSION - INGENIUM I4 2.0L DIESEL

Refer to: TRANSMISSION - INGENIUM I4 2.0L PETROL

Refer to: TRANSMISSION - INGENIUM I6 3.0L PETROL
CAUTION: Be prepared to collect escaping fluids.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Use the special tools to remove the torque converter.

Special Tool(s): 307-613
CAUTION: Care must be taken to avoid damage to the seal register and running surface.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Use the special tools to remove the seal.

Special Tool(s): 100-012 , 100-012-01 , 308-375