Crankshaft Pulley - INGENIUM I4 2.0L Petrol (G2344447): Removal

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING
Disconnect the startup battery ground cable.
Refer to: SPECIFICATIONS
Remove the accessory drive belt.
Refer to: ACCESSORY DRIVE BELT - INGENIUM I4 2.0L PETROL
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the special tool as illustrated.

Special Tool(s): JLR-303-1630
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove and discard the 4 bolts.
CAUTION:
- Only rotate the crankshaft clockwise.
- Make sure the special tool is correctly aligned.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the special tool.
  Special Tool(s): JLR-303-1630
- Remove the crankshaft pulley.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the special tool.
  Special Tool(s): JLR-303-1628
- Use the special tool to rotate the crankshaft front seal 35° in a counter-clockwise direction.
- Discard the crankshaft front seal.